DOH

O7 is a super beefed up version of O1. Rockwell is 63 and it performs very well at this hardness. This stuff holds an edge forever. It is not stainless though.

Remington Pattern Knife- RPK

This one is based off of a remington knife from a customer. Very handy little knife. Perfect for bushcraft.

WASP

This one was a skeleton knife that I traded to get back. Wrapped the handles with cord and epoxy soaked for better grip. .250 thick. Front edge is sharp too.

EDC XL

This would make a great camp knife or all around knife. The front/tip is also sharp to use like a chisel. Comes with kydex sheath. Hand rubbed to 600 and then stonewashed.

JPT

This one is chisel ground, bead blasted and stonewashed. There is one little pit on the flat side that I couldn't sand/grind out without changing the blade too much. It is from a lumber mill after all. Comes with Kydex Right hand crossdraw sheath and belt loop.

FN- Favorite Necker

This is my favorite pattern of neck knife. 48" hollow grind, ground very thin for great cutting. Comes with kydex sheath for pocket carry or around the neck with a ball chain or paracord. 1/8 thick blade. I also have a very similar one with red/black G10.

Timascus ring

This is a 12mm wide timascus ring. It is a comfort fit band and has been heat colored to show the two different kinds of Ti the best. Size is 11 1/4 but because of the width it wears like a 10 3/4.

Damascus Rings

Made from a billet of damascus steel. I still have enough for a couple more rings left. Width, thickness, and profile can all affect ultimate price. A little more care needed with these but well worth the effort.